Chain tension/wheel alignment

[His Dudeness]

Hello all,

Fitted rear wheel back on, with new chain etc, however have an issue after setting chain tension (the two nuts on thread at rear of Swingarm).

The rear cover at back of Swingarm is loose, so something isn't right. Plus if I'm tightening those adjustment nuts so it pushes the end 'caps' tight against back of Swingarm then chain becomes too tight.  :rolleyes

Any feedback would be greatly appreciated.

[smg id=3257 type=preview align=center caption="20190307 184400"]

Cheers.

It's a bit late now but I saw another good tip to prevent this. If you pull the slack side of the chain up towards the swingarm as you're tightening the axle bolt. That should pull the adjusters forward and seat the covers in the swingarm