27-01-19, 05:33 PM
Setting it up as per above, the only way I could get the 5k-10k bounce was to back off the tickover setting as mentioned before.
Even then it seems to be a bit hit or miss.
Of course when I started the bike it wouldn’t tick over!
Adjusted it back up to 1k or so.
When I went back to check again today (I know I should just leave it!) it was at 10k and I couldn’t seem to get it to change without dropping the tickover setting again.
Having a rummage around in the Haynes manual I noticed it said that for 2001/2002 bikes you should use the 5k/10k adjustment method, but for 2003 on you just measure the output voltage of the sensor.
Doing that seems to be a bit easier, but Ive not seen it mentioned here or on the “bible” website either.
Does that mean its not worth using?
Even then it seems to be a bit hit or miss.
Of course when I started the bike it wouldn’t tick over!
Adjusted it back up to 1k or so.
When I went back to check again today (I know I should just leave it!) it was at 10k and I couldn’t seem to get it to change without dropping the tickover setting again.
Having a rummage around in the Haynes manual I noticed it said that for 2001/2002 bikes you should use the 5k/10k adjustment method, but for 2003 on you just measure the output voltage of the sensor.
Doing that seems to be a bit easier, but Ive not seen it mentioned here or on the “bible” website either.
Does that mean its not worth using?