29-12-18, 10:50 PM
I have checked and no o'rings. The picture in a pdf manual is wrong of showing o'rings, so waiting for the bottom gasket to arrive.
I have checked the head and cylinder and both are within 0.05 of warpage. Just out of interest what have people on here used as a flat edge with wet and dry to skim the heads or have you taken them to a machine shop to get skimmed?..
The exhaust valves have very slight leaks, so will use my stick to lapp them in. The inlets are fine, but as I have the head off, I will change the seals and give them a clean and lapp them in.
I will update with any problems and tips I come across.
I have checked the head and cylinder and both are within 0.05 of warpage. Just out of interest what have people on here used as a flat edge with wet and dry to skim the heads or have you taken them to a machine shop to get skimmed?..
The exhaust valves have very slight leaks, so will use my stick to lapp them in. The inlets are fine, but as I have the head off, I will change the seals and give them a clean and lapp them in.
I will update with any problems and tips I come across.