08-10-18, 08:31 AM
(07-10-18, 05:10 PM)MFD link Wrote: Today I battled my way into the timing cover to check the valve clearances, all in spec... except ONE SODDING VALVE.
Debating leaving it since its <0.01mm too tight, but out of spec is out of spec...
I have the same issue on my 4th cylinder. I decided in the end I would wait until a few more of them were close to spec otherwise I would just have to repeat the process and it's a right ballache getting the cams out. 0.01 isn't going to make much difference.