15-08-18, 04:51 PM
Majority of the down pipe/header flanges on aftermarket pipes are cast alloy not stainless & will bend when torqued anywhere near to 10nm.[img alt=Smile]http://foc-u.co.uk/Smileys/efocicon/smile.gif[/img]
Fazer Owners Club - Unofficial
›
Bikes, Hints'n'Tips
›
FZS600 Fazer
Exhaust stud removal- should I attempt it????
Exhaust stud removal- should I attempt it????
|
Exhaust stud removal- should I attempt it????
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Exhaust stud removal- should I attempt it???? - by hopefiendboy - 08-08-18, 10:57 PM
Re: Exhaust stud removal- should I attempt it???? - by hopefiendboy - 08-08-18, 11:00 PM
Re: Exhaust stud removal- should I attempt it???? - by bandit - 08-08-18, 11:28 PM
Re: Exhaust stud removal- should I attempt it???? - by Bretty - 10-08-18, 04:09 PM
Re: Exhaust stud removal- should I attempt it???? - by adasilva - 13-08-18, 07:25 PM
Re: Exhaust stud removal- should I attempt it???? - by fazersharp - 13-08-18, 07:45 PM
Re: Exhaust stud removal- should I attempt it???? - by hopefiendboy - 15-08-18, 11:47 AM
Re: Exhaust stud removal- should I attempt it???? - by tommyardin - 15-08-18, 04:29 PM
Re: Exhaust stud removal- should I attempt it???? - by bandit - 15-08-18, 04:51 PM
Re: Exhaust stud removal- should I attempt it???? - by tommyardin - 15-08-18, 07:49 PM
Re: Exhaust stud removal- should I attempt it???? - by tommyardin - 15-08-18, 08:04 PM
|
Users browsing this thread: