07-08-18, 10:05 PM
:useless Lol if they're Renthals which seem most common then they are anodised.
If originals you can quickly check some of these things
[size=78%] slip off the throttle or left switch controls there will be a small hole in the bars maybe 4mm? to keep the controls fixed firm [/size]
[/size][size=78%]lift one of the brackets mounting it to the yolk risers and it will have notches cut into it for grip[/size]
[/size][size=78%]If you remove one of the bar ends it will look like the thread in the bars is an insert which is welded in [/size]
[/size][size=78%]There is also a number stamped on the bars at the clutch grip end although this is impractical to view[/size]
[/size][size=78%]There is likely a dot punched into the bars as a marker near the mounting point with the risers [/size]
If originals you can quickly check some of these things
[size=78%] slip off the throttle or left switch controls there will be a small hole in the bars maybe 4mm? to keep the controls fixed firm [/size]
[/size][size=78%]lift one of the brackets mounting it to the yolk risers and it will have notches cut into it for grip[/size]
[/size][size=78%]If you remove one of the bar ends it will look like the thread in the bars is an insert which is welded in [/size]
[/size][size=78%]There is also a number stamped on the bars at the clutch grip end although this is impractical to view[/size]
[/size][size=78%]There is likely a dot punched into the bars as a marker near the mounting point with the risers [/size]