Fitting an Ivans kit, any advice re do's and don'ts?

[ProdigalSon]

As someone in the same boat wanting to do this, if anything Mike's post has put me off haha

I am bound to fuck something up!!

I'll just keep telling myself it feels fine I think lol

Well it took me considerably longer than the 15 minutes it takes Mike to pull the carbs but I was being very careful and it took me a while to work out how to disconnect the throttle cables and get to the 2nd from right inlet stub clamp allen bolt due to the cam chain tensioner. I've done the stripping down and cleaned up my carbs and I shall set about doing the actual modding tomorrow. Don't be put off  doing it just be patient and take your time, ideally if you haven't got them buy a set of extra long allen keys for the inlet stubs it will make your life a whole lot easier. Also I disconnected the throttle cables at the handlebars and you then release the bottom ends once you slide the carbs out.


Graham.