Bar end weights

[Triggergee]

Oberon used to do very heavy stainless end weights that didn't need the bars tapped, the just bolt in with an expanding bolt setup.
Personally, I've tried various setups with no difference in vibration at all. I'm currently using R&G weights that screw into the standard bars and I can't feel any difference in vibration.


Jim.

If your talking about the R&G stainless with slider ends those were the ones I was looking at and the screw in ones are about 200g each compared to the 307g OEM which is closer than most others. Hopefully I'll tap out the Renthals properly and then at least I can change to the R&G weights at some point