25-03-18, 12:39 AM
(This post was last modified: 25-03-18, 12:41 AM by Disorderlypunk.)
is it just me that see's a better compromise between the two ?
would a 12mm nut with a 3mm gap be even better?
ok that extra 1mm wont be on a thread but would reduce torsional stress/flex
yes i already know the reduction would be minimal but as tesco says 'every little helps'
great drawing by the way - great to see stuff like that when its not coming from a design aspect but more a 'what is there' aspect
would a 12mm nut with a 3mm gap be even better?
ok that extra 1mm wont be on a thread but would reduce torsional stress/flex
yes i already know the reduction would be minimal but as tesco says 'every little helps'
great drawing by the way - great to see stuff like that when its not coming from a design aspect but more a 'what is there' aspect
riding this that and the other
vloggin some bits - https://www.youtube.com/channel/UCvWtJO9...R9RNHx72UQ
https://www.instagram.com/disorderly_punk_yt/
vloggin some bits - https://www.youtube.com/channel/UCvWtJO9...R9RNHx72UQ
https://www.instagram.com/disorderly_punk_yt/