Forks modification advice

[Triggergee]

Really appreciate your help on this tommyardin! Going fine so far, got the two existing holes drilled out to 8mm but needed to go out to buy a new 10mm bit. The emulators are a pretty good fit on the rods but do have a little wiggle room, maybe a mil or two but I guess the springs hold them down enough to make a good seal. I've set them to 2.5 turns from initial spring contact. So just drop them down the tubes and they should slot on nicely... as soon as the new dust seals come I'll drive the bike into my kitchen (don't have a garage) and swap everything over    then ill start wondering how to mod the rear shock