Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Forks modification advice
#26
It put up a good fight but I'm relieved to say I won! The spring pressure wasn't enough even with me putting all my weight on it. To go the broom handle route as I said I had to cut the bent part of the stanchion off which I would've had to do anyway to get the spring and hopefully damper rod out.
Broom handle didn't work to bite into the damper so I tried a cricket post which fits up into the damping rod top and gripped good but then the whole thing span as one...


In the end I put an 8mm Allen key through the top brake calliper mounting hole and used a ratchet strap round that and the cricket post to exhert more force than I could using my body and used as you say a battery impact driver and after maybe a minute of that it finally gave in!


Thanks for the petrol tip I'll make sure to give it all a good wash out. Right now one of the damping rods which had a slight bit of corrosion I'm guessing because the stanchion was so bent it split and was already drained of oil  is having a little soak with some acf 50 and tomorrow I'll give it a gentle rub with some wire wool. For today though I've got a bottle of 10% abv wheat wine from the brewery at the end of my road to celebrate my victory with  :lol
Reply


Messages In This Thread
Forks modification advice - by Triggergee - 14-03-18, 06:19 PM
Re: Damaged Forks and modification advise - by daviee - 14-03-18, 06:59 PM
Re: Damaged Forks and modification advise - by daviee - 14-03-18, 07:51 PM
Re: Damaged Forks and modification advise - by Triggergee - 16-03-18, 06:44 PM
Re: Forks modification advice - by tommyardin - 16-03-18, 10:18 PM
Re: Forks modification advice - by Triggergee - 22-03-18, 11:03 AM
Re: Forks modification advice - by tommyardin - 22-03-18, 12:50 PM
Re: Forks modification advice - by Triggergee - 23-03-18, 09:42 PM
Re: Forks modification advice - by tommyardin - 23-03-18, 11:10 PM
Re: Forks modification advice - by Triggergee - 27-03-18, 07:09 PM
Re: Forks modification advice - by Triggergee - 06-04-18, 04:57 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)