Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Forks modification advice
#9
Tommyyardin did you use a drill press to drill the holes or do it freehand? To be clear for the first/lowest 10mm hole you filed down the bottom of the 5mm hole by 3mm and started to drill the 10mm holes from there? Is it possible to measure the 3mm and use a centre punch to start the drilling or would this not work?
Reply


Messages In This Thread
Forks modification advice - by Triggergee - 14-03-18, 06:19 PM
Re: Damaged Forks and modification advise - by daviee - 14-03-18, 06:59 PM
Re: Damaged Forks and modification advise - by daviee - 14-03-18, 07:51 PM
Re: Damaged Forks and modification advise - by Triggergee - 15-03-18, 12:30 AM
Re: Forks modification advice - by tommyardin - 16-03-18, 10:18 PM
Re: Forks modification advice - by Triggergee - 22-03-18, 11:03 AM
Re: Forks modification advice - by tommyardin - 22-03-18, 12:50 PM
Re: Forks modification advice - by Triggergee - 23-03-18, 09:42 PM
Re: Forks modification advice - by tommyardin - 23-03-18, 11:10 PM
Re: Forks modification advice - by Triggergee - 27-03-18, 07:09 PM
Re: Forks modification advice - by Triggergee - 06-04-18, 04:57 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)