22-01-18, 10:16 PM
Hi Mitch
All stock parts and settings for a pre-2003 model. Well, mid-2003 to be precise but that's trivia.
I'd reassemble using the 3mm spacers which was how Yamaha shipped the Fazer from mid-2003 onwards. It was their way of addressing the lean surge issues which affected the earlier versions of the bike. You will still need one 0.5mm shim below the spacer and another on top of the e-clip to act as a seat for the needle retaining spring.
Set the mixture screws to 3.5 turns out and call it good for now.
All stock parts and settings for a pre-2003 model. Well, mid-2003 to be precise but that's trivia.
I'd reassemble using the 3mm spacers which was how Yamaha shipped the Fazer from mid-2003 onwards. It was their way of addressing the lean surge issues which affected the earlier versions of the bike. You will still need one 0.5mm shim below the spacer and another on top of the e-clip to act as a seat for the needle retaining spring.
Set the mixture screws to 3.5 turns out and call it good for now.