Fitting aftermarket fairing

[Disorderlypunk]

if these are not available anymore you might be able to fashion up some brackets using what is available from diy stores and ebay
just google the names of stuff and you will find them (you will have to measure stuff though)


fig 4+3 shows what would be called a munsen ring - readily available, even at screwfix


fig 2 is just a munsen ring backplate which are usually flat
------- because of the spacing here i would just make up the plate myself with alloy flat bar then drill a central hole to short bolt a threaded spacer to create this piece then use a washer between the fairing and threaded spacer to stop it breaking through


fig 1 - this is where you are going to have to get really creative with a piece of alloy flat bar and a vice to start bending it (impossible to guess from a drawing)


there are rubber lined munsen rings out there but its on you to find them


hope this gives you a backup if nothing else is available