07-01-18, 10:27 PM
as your going in there then just wait and check everything
standard jets are 115 across the board
if its over fueling then my first guess would be float heights which is enough to check with a piece of pipe and a small ruler
i think is about 4.5mm above carb bowl lip (pre 2000) and 3.5mm (2000 onwards)
get yourself some m4 10mm (i think) full thread cap screws you will want 16 of them and you can replace the shitty screws that hold the bowls to the carbs - for a couple of quid its better to have them and not need them than to need them and not have them and it makes life so much easier in the future
standard jets are 115 across the board
if its over fueling then my first guess would be float heights which is enough to check with a piece of pipe and a small ruler
i think is about 4.5mm above carb bowl lip (pre 2000) and 3.5mm (2000 onwards)
get yourself some m4 10mm (i think) full thread cap screws you will want 16 of them and you can replace the shitty screws that hold the bowls to the carbs - for a couple of quid its better to have them and not need them than to need them and not have them and it makes life so much easier in the future
riding this that and the other
vloggin some bits - https://www.youtube.com/channel/UCvWtJO9...R9RNHx72UQ
https://www.instagram.com/disorderly_punk_yt/
vloggin some bits - https://www.youtube.com/channel/UCvWtJO9...R9RNHx72UQ
https://www.instagram.com/disorderly_punk_yt/