Replacing HT Leads and Plug Caps/Boots

[His Dudeness]

I had managed to change the ht leads at my coils with success.
Its a bit risky job,but ok.The oem leads are glued to the coils with some kind of epoxy maybe(?).
I removed them and clean the hole,at the end inside the coils there is something like a spike.
Install the new ones with some high heat silicone-gasket silicone.
Everything seems fine for months now.
I wish i could afford some dynatec doils!


One mod i did these days,is i took the oem spark plug caps and removed the resistor they have inside.(i have allready ngk spark plugs)
After some internet research,you dont need a resitance spark plug cap when you have a resistance spark plug allready.
It seem to work better at low revs,but nothing sure yet,maybe its my mind. :b

Is there a screw in type connection under the epoxy or is it just the epoxy that holds the lead in?

I'll be trying the rubber plug caps next time. They're one piece so I think they'll keep the water out better than the ones with the rubber boot on the end