Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Last job is to balance the carbs, and I can't seem to get it right
#5
Tommy - that reminds me, something I forgot to mention: My throttle was acting a little strange as well. I don't think I reconnected them properly after tearing down the carbs. It's almost like it isn't springing back to idle. If I manually roll the throttle forward the revs dropped right off, almost cutting the engine out. It stays like that till I blip on the revs again. I guess there is a decent section on throttle setup in the Haynes manual that I should read through.
Reply


Messages In This Thread
Re: Last job is to balance the carbs, and I can't seem to get it right - by redmandan - 07-11-17, 02:37 AM

Forum Jump:


Users browsing this thread: