31-10-17, 06:45 PM
Split the caliper then change the seals. Make sure you clean out the groves, a round wire brass dremmel wheel is ideal these groves will be corroded pushing seals out so the piston sticks.
Don't loose the small oring between two halves. Polish pistons or replace if pitted on surface in contact with seal. Use red rubber grease when fitting seals.
Good as new.
Hope that helps.
Don't loose the small oring between two halves. Polish pistons or replace if pitted on surface in contact with seal. Use red rubber grease when fitting seals.
Good as new.
Hope that helps.