(13-10-17, 08:20 AM)F4celess link Wrote:Sounds promising.If you want better vibration dampening I cant recommend getting the bars tapped out for the OEM bar ends enough, someone did suggest rolling up a strip of roofing lead and gluing these inside the bars if you didn't want to keep the OEM ends. From personal experience lightweight aftermarket bar ends make the vibrations through the bars a heck of a lot worse, although you can get used to this over time.Measuring the width of my stock Yamaha bars plus bar ends fitted, 700mm. These Renthals are only about 5cm wider.
Plus they are supposed to offer much better vibration damping, so I wont cut them down, will slide the Renthal grips straight on.
Do your wider bars catch the tank however, at full lock?
I have the GYT-R bar risers which are lower than the OEM risers so will bring the bars closer to the tank, with the bars properly adjusted the switchgear blocks are about 4" away from the tank at full lock so not an issue and less so if you have the taller OEM bar risers. Happy to take photo's if they would be useful.