09-10-17, 11:51 AM
I fitted new discs a month or two ago. Blow torch and heat is definitely the way to go. You don't need them red hot (they would be softer when cooled) but a minute or two for each bolt.
You'll need to shield your bearings from the heat. I used an oil filter wrench thing with foil inside it just sat over the top of the bearings.
And also good whack or two with a hammer or rubber mallet straight down on to your allen attachment to shock them.
They should then come out fine.
Andy
You'll need to shield your bearings from the heat. I used an oil filter wrench thing with foil inside it just sat over the top of the bearings.
And also good whack or two with a hammer or rubber mallet straight down on to your allen attachment to shock them.
They should then come out fine.
Andy