|
Gas welding safety question
|
29-09-17, 04:59 PM
Can a knowledgeable person on gas welding/brazing safety tell me if it is safe to use any of the following equipment which hass not been used for about twenty years:- regulators, flash arrestors, hoses with check valves and a lightweight torch. Also a small acetylene cylinder which still contains some acetylene. Or should i ditch the lot and start afresh with new equipment. (I think I know what the answer will be!) [smg id=3029] [smg id=3030] |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Gas welding safety question - by limax2 - 29-09-17, 04:59 PM
Re: Gas welding safety question - by BBROWN1664 - 29-09-17, 05:16 PM
Re: Gas welding safety question - by tommyardin - 29-09-17, 05:21 PM
Re: Gas welding safety question - by tommyardin - 29-09-17, 05:26 PM
Re: Gas welding safety question - by lew600fazer - 29-09-17, 06:18 PM
Re: Gas welding safety question - by limax2 - 29-09-17, 06:33 PM
Re: Gas welding safety question - by tommyardin - 29-09-17, 06:48 PM
Re: Gas welding safety question - by limax2 - 29-09-17, 10:21 PM
Re: Gas welding safety question - by mtread - 29-09-17, 11:54 PM
Re: Gas welding safety question - by celticdog - 30-09-17, 12:37 AM
Re: Gas welding safety question - by limax2 - 02-10-17, 08:35 AM
Re: Gas welding safety question - by Bretty - 03-10-17, 07:52 PM
Re: Gas welding safety question - by DILLIGAFF - 04-10-17, 10:27 AM
|
