|
exhaust / dyno question
|
28-09-17, 05:12 PM
Just drill a hole in each downpipe and weld a nut over the hole then fit a short bolt into the nut. Job done.
Theoretically they are used for exhaust gas analysis on a per cylinder level but I don't think anyone has ever used them (not even Yamaha)
Another ex-Fazer rider that is a foccer again
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
exhaust / dyno question - by Disorderlypunk - 28-09-17, 03:49 PM
Re: exhaust / dyno question - by BBROWN1664 - 28-09-17, 05:12 PM
Re: exhaust / dyno question - by darrsi - 28-09-17, 07:26 PM
Re: exhaust / dyno question - by Disorderlypunk - 28-09-17, 07:44 PM
Re: exhaust / dyno question - by darrsi - 28-09-17, 08:02 PM
Re: exhaust / dyno question - by daviee - 28-09-17, 08:02 PM
Re: exhaust / dyno question - by Disorderlypunk - 28-09-17, 08:15 PM
Re: exhaust / dyno question - by Disorderlypunk - 28-09-17, 11:23 PM
Re: exhaust / dyno question - by darrsi - 29-09-17, 06:39 AM
Re: exhaust / dyno question - by Disorderlypunk - 29-09-17, 11:40 AM
|
