15-08-17, 06:03 PM
Was a complete seal kit. Spring, circlip, piston with seal pre-attached and the seal that goes between the piston and the spring. I am fairly sure that I put them in correctly. It did work and gave me a good brake for a few miles before it failed again. I have tried google but didn't get too much useful info. I have tried bleeding it again and have a good lever, but I still don't trust it. The kit was an after market one so I am tempted to buy a Yam one. The fact that it fails completely with no evidence of leaks makes me think it has to be the master cylinder itself or the seals in it. Will keep looking. Was just hoping someone had experienced something similar and could point me in the right direction. Thanks for the info.