06-08-17, 11:09 AM
I've updated my profile with my bike now! Can't believe how helpful you all are here and how quick you've replied!
Whipped the clutch cover off again this morning, tried the pressure plate in a few different ways but it didn't seem to make any difference. Looking at either side of the plate is seems to be symmetrical and I couldn't see any difference in fitting.
I think I may have figured out what's wrong though. The inside of my casing had a tiny rub mark from the clutch. I think that the cable is worn to the point that to get any feel from the lever I'm needed to screw the push rod adjuster too far in, meaning the clutch won't disengage. I think a new cable (which I've ordered) should cure it!
The plates were fairly worn so I'm gonna convince myself it was worth changing them rather than wasting money haha.
I'll update once I've fitted the cable but at the minute I think that's the problem
Thanks for all your help! Carl
Whipped the clutch cover off again this morning, tried the pressure plate in a few different ways but it didn't seem to make any difference. Looking at either side of the plate is seems to be symmetrical and I couldn't see any difference in fitting.
I think I may have figured out what's wrong though. The inside of my casing had a tiny rub mark from the clutch. I think that the cable is worn to the point that to get any feel from the lever I'm needed to screw the push rod adjuster too far in, meaning the clutch won't disengage. I think a new cable (which I've ordered) should cure it!
The plates were fairly worn so I'm gonna convince myself it was worth changing them rather than wasting money haha.
I'll update once I've fitted the cable but at the minute I think that's the problem
Thanks for all your help! Carl