06-08-17, 12:47 AM
Thanks for the replies! To answer a few questions yes the plates were soaked in oil and it's a bike specific fully synthetic so shouldn't cause any problems?
I was considering ordering a clutch cable.
I could possibly of fitted the pressure plate wrong. I thought it would go on any way tbh and it clicked straight in the first way I tried. I'll whip the clutch cover off in the morning and turn it a try again.
Yeah I fitted the anti judder ring too. Friction first, then steel then judder then friction so on until I ended on a friction which is the same way it came out so I think that should be right?
Steels didn't have any discolouration at all that I could notice. I didn't pay much attention to whether they were warped or not though
I was considering ordering a clutch cable.
I could possibly of fitted the pressure plate wrong. I thought it would go on any way tbh and it clicked straight in the first way I tried. I'll whip the clutch cover off in the morning and turn it a try again.
Yeah I fitted the anti judder ring too. Friction first, then steel then judder then friction so on until I ended on a friction which is the same way it came out so I think that should be right?
Steels didn't have any discolouration at all that I could notice. I didn't pay much attention to whether they were warped or not though