15-07-17, 11:00 PM
Hi matey.
Best mod you can do is drill the basket..IMHO!!
Most clutch baskets don't allow enough oil flow thru the rear plates, hence run hot & warp the steel plates.
Check out pics of a Sigma Race clutch basket on internet, it'll be a slipper basket set up, but still a clutch basket all the same.
Done all my bikes over the yrs, mucho improvement, virtually no drag if any.
I also tidy up basket fingers where friction plate tangs sit with a fine file then 800 grit wet'n'dry.
Clutch will be loads improved.
As said by others, might as well change the full clutch while it's stripped (I would).
EBC Kevlar series race plates seem to last a good while, springs are a bit heavier, so lever feel will be heavier as a result.
Change oil often too, helps no end.
Rgds
Gaz
Best mod you can do is drill the basket..IMHO!!
Most clutch baskets don't allow enough oil flow thru the rear plates, hence run hot & warp the steel plates.
Check out pics of a Sigma Race clutch basket on internet, it'll be a slipper basket set up, but still a clutch basket all the same.
Done all my bikes over the yrs, mucho improvement, virtually no drag if any.
I also tidy up basket fingers where friction plate tangs sit with a fine file then 800 grit wet'n'dry.
Clutch will be loads improved.
As said by others, might as well change the full clutch while it's stripped (I would).
EBC Kevlar series race plates seem to last a good while, springs are a bit heavier, so lever feel will be heavier as a result.
Change oil often too, helps no end.
Rgds
Gaz