25-06-17, 04:44 PM
Hi Guys,
First time I have ever done this so just wanted some words of advice really.
Have checked the clearances as best I can ( I hope :S) some of the tolerances seem right on the edge of minimum.
Would you recommend leaving them, or if shimming is required, which ones?
Worth getting someone else to double check?
Have attached picture of my measurements.
Many thanks in advance
First time I have ever done this so just wanted some words of advice really.
Have checked the clearances as best I can ( I hope :S) some of the tolerances seem right on the edge of minimum.
Would you recommend leaving them, or if shimming is required, which ones?
Worth getting someone else to double check?
Have attached picture of my measurements.
Many thanks in advance