10-06-17, 07:54 AM
(10-06-17, 12:47 AM)nitheesh link Wrote: Ok, I followed the below steps:
1. Turned on the ignition (Few seconds later it started showing 3000 fault code)
2. Removed the tps connector (showing 3000 fault code as expected)
3. Blow some air into the connector and tps.
4. Connected it back - Odo just stayed at 0 after connecting, and few seconds later it showed 3000 fault code again.
Does this mean an issues with the connector wire/tps? I want to check if there power at the connector ends but I dont have a multi meter :o
It can't be any more blatant......the 'fault' code is doing just that......showing a fault.
Time for a new one.
More people are born because of alcohol than will ever die from it.