R6 shock Mod fazer 1000

[devilsyam]

as this has happened after fork fit id be inclined to check front setting look for for sticksion make sure both legs have same setting
go back to factory settings as yo need a base point to work from

sticksion is when the fork are clamped either resting on the deck or if yokes tightened oddly

the way to remove it is lift front end remove wheel undo clamps so legs are relaxed

nip uo lower yoke first just enough to hold the leg

now tighten top yoke bit at a time left then right till both are torqued

now undo the lower yoke till bolts are loose this allows any tension out again clamp either side bit by bit till torqued

assuming all bearings are good and your happy go try it

also ive come across alot of fazers in my time were the front wheel is over tightened so check torque on this to

let me know how you get on