Hi Peeps
I'm new to Fazers.
Having some electrical gremlins.
Just unpicked a right rats nest of Meta alarm loom bodging.
Alarm had failed before I got the bike, alarm multi-plug had the usual bypass bridging wire (poorly done).
Anyway alarm looms out, both of the alarm multi-plug connectors in the bikes loom under seat have been put back & bridged as per factory spec, bikes a runner.
For some reason I've lost live feed to dip/main beam & dash clocks illumination?.
Could just be a coincidence that some other fault is present, but lights worked prior to removing alarm loom.
Struggling to find what the unused 3pin connector is for next to alarm multi-plug connectors in bikes loom?.
Tested, I have 2 earths & a switched live
Is it for accessories
Any ideas pls?
I suspect ignition switch is faulty? Yet to confirm.
I'm just on with working thru loom.
Headlamp relays test correct as per manual.
Everything works except dip/main & dash clocks illumination.
Finding corroded pins in multi-plugs above rocker cover, removing male/female pins to clean.
Is this a known headlamp fault based on the issues I'm having?
Any helpful ideas are very much appreciated.
Rgds
Gaz
I'm new to Fazers.
Having some electrical gremlins.
Just unpicked a right rats nest of Meta alarm loom bodging.
Alarm had failed before I got the bike, alarm multi-plug had the usual bypass bridging wire (poorly done).
Anyway alarm looms out, both of the alarm multi-plug connectors in the bikes loom under seat have been put back & bridged as per factory spec, bikes a runner.
For some reason I've lost live feed to dip/main beam & dash clocks illumination?.
Could just be a coincidence that some other fault is present, but lights worked prior to removing alarm loom.
Struggling to find what the unused 3pin connector is for next to alarm multi-plug connectors in bikes loom?.
Tested, I have 2 earths & a switched live
Is it for accessories
Any ideas pls?
I suspect ignition switch is faulty? Yet to confirm.
I'm just on with working thru loom.
Headlamp relays test correct as per manual.
Everything works except dip/main & dash clocks illumination.
Finding corroded pins in multi-plugs above rocker cover, removing male/female pins to clean.
Is this a known headlamp fault based on the issues I'm having?
Any helpful ideas are very much appreciated.
Rgds
Gaz