22-04-17, 03:31 PM
Pulled the swingarm from the ZZR and surprise surprise the needle rollers are shot
A kit is about £50 inc new seals etc but the seals are servicable so really just need a set of bearings
Anyone out there used non stock bearings and if so how did you get on and where did you buy them from (I know its not the same bike)
A kit is about £50 inc new seals etc but the seals are servicable so really just need a set of bearings
Anyone out there used non stock bearings and if so how did you get on and where did you buy them from (I know its not the same bike)
Complete fabrication, I didn't make it up!