Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Who's done what to their forks? And are you happy with them?
#13
Vinny,
Try putting in 15 weight oil and if you feel its a little harsh/overly firm just loosen of the two top yoke to fork leg pinch bolts, Make sure the front wheel is off the ground Ie: no weight on the wheel, then unscrew the top of fork leg cap bolts and with a syringe and a sort length of fish tank air line draw out a measured amount of the 15 weight and replace it with the same amount of 10 weight or even 5 weight until you are happy with the results.
When you draw out the say 10ml of 15 weight oil into the syringe while the fish tank pipe is still in the fork leg pull the pipe off the syringe so that the oil in the pipe runs back into the leg.
To put the replacement oil back into the leg you do not need the pipe, so it will be exactly what you have in the syringe that goes back into the leg.
It's just fine tuning the oil weight really. It should take no longer than 30 mins to do the oil tuning.

DON'T FORGET the top yoke pinch bolts, 30 Nm torque.

Top of fork leg plug nuts 23Nm torque.
Good luck. :thumbup
Reply


Messages In This Thread
Re: Who's done what to their forks? And are you happy with them? - by tommyardin - 18-04-17, 10:47 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)