(20-03-17, 05:48 PM)Dustydes link Wrote: 758's are a good choice most seem to go with.
I fitted them last year, very pleased with them, better handing.
All controls fit and as said you can tap out ends to take standard or after market end weights.
No need to drill bar just tap out. 16mmx1.5 pitch
You will need to drill a hole in the right place for each control or file nib off controls and use tape.
I drilled holes so no chance of slip when glue on tape gets hot, but no one seems to have problems with tape.
Dustydes, did you have to coarse cut then fine cut the thread on the bars or just the fine, I can get a fine for £4 but a set for £14, wouldn't contemplate not doing a coarse if it was steel but it's girly alloy. Ordered the ultra lows working on the assumption that everyone else can't be wrong.
Cheers
Carl
It's easier to get more money than it is a day of your life back.