Stainless Downpipes

[tommyardin]

Here you are I did this last year in sit-u here is my post
------------------------------------------------------------------------------------------------------------------------------
Finished it off today, 1st out for a 10mile spin to get the filler fully hardened and then some masking off and a spray with Rust-oleums stove and bbq paint. It took so long to mask off that it would of been quicker to take it off but as I have never taken it off I have no time for "unknowns" as I plan to get the MOT on Monday. (my stud nuts are good as I have had them off and copper greased)
Just need to take it for another spin tomorrow to bake on the paint
I usually use Granviles engine paint but have found that it can flake off, somewhere on this forum a member recommenced the Rust-oleum so I thought I would give it a go.     
[img alt=*]http://foc-u.co.uk/Themes/Crushing/images/icons/clip.gif[/img] Photo1233.jpg (361.05 kB, 1600x1200 - viewed 8 times.)

[img alt=*]http://foc-u.co.uk/Themes/Crushing/images/icons/clip.gif[/img] Photo1238.jpg (324.51 kB, 1600x1200 - viewed 6 times.)

[img alt=*]http://foc-u.co.uk/Themes/Crushing/images/icons/clip.gif[/img] Photo1239.jpg (264.58 kB, 1600x1200 - viewed 6 times.)
 
Here are my 2 little holes - first pic before a good going over with a wire wheel on a drill
Next picture after a set to with the drill
Next and still to come will be photos now I have filled with gun gum I just need some dry roads to give it a run and heat it up to full hardening
 
 
[img alt=*]http://foc-u.co.uk/Themes/Crushing/images/icons/clip.gif[/img] Photo1215[1].jpg (250.03 kB, 1600x1200 - viewed 7 times.)

[img alt=*]http://foc-u.co.uk/Themes/Crushing/images/icons/clip.gif[/img] Photo1224[1].jpg (197.33 kB, 1600x1200 - viewed 6 times.)

[img alt=*]http://foc-u.co.uk/Themes/Crushing/images/icons/clip.gif[/img] Photo1226[1].jpg (259.18 kB, 1600x1200 - viewed 6 times.)

Hey Sharpie, Get that centre stand and spring sorted you naughty lil racing snake you