29-09-16, 02:18 PM
(28-09-16, 10:11 PM)Fazerjon link Wrote: They look really good, I think I'll take the plunge and go for it. I have the standard bars and bar ends (I tried the ultra low Renthal bars but couldn't get on with them) so will they fit to the standard OE bars/bar ends or do I need to modify or replace the the bar ends?
Never tried to fit them to standard bars and ends but cant see why not. You might have to trim grips a bit as I did due to switches locating in a hole in bars so you cant move throttle the 5mm needed .
Or go with Mick-H and use the ones that replace the bar weight.
I didn't go down this route because it gets rid of bar end weight and might increase vibration, they also add a bit more width than mine.
Some have added weight to the bars internally to get around this.
Mick-H could tell you about added vibration with dampers removed, if any ???