21-09-16, 12:57 PM
Centre stand is fine.
The handlebars have the weights attached and an additional 25mm length of 20mm rebar added on (with hole in for fixing bolt) for good measure.
Might try filling the bars with lead shot and silicon sealant or sand, just to make sure
Would fixing some heavy weights to the outer edge of the footpegs help at all ?
I had a go on a fuel injected Triumph TT600 recently...and it was about the same as mine anyway, so maybe I'm expecting too much. It's just that previous bikes have been as smooth as silk all the way up the rev range even with no handlebar end weights !
The handlebars have the weights attached and an additional 25mm length of 20mm rebar added on (with hole in for fixing bolt) for good measure.
Might try filling the bars with lead shot and silicon sealant or sand, just to make sure
Would fixing some heavy weights to the outer edge of the footpegs help at all ?I had a go on a fuel injected Triumph TT600 recently...and it was about the same as mine anyway, so maybe I'm expecting too much. It's just that previous bikes have been as smooth as silk all the way up the rev range even with no handlebar end weights !