Headstock Bearing questions

[Dave48]

[quote author=Dave48 link=topic=21068.msg241919#msg241919 date=1474347537]
Welcome to the world of "Fazership"!
I have exactly the same model as yours-mine is a 2000 build(5DMA) but with a 2001 "Y" registration. Yours looks in good condition-mine came with the usual cracks on the nose cone where bike had been dropped by previous owner so have a bit of plastic welding to do over winter months.
Otherwise have done all the service/maintenance jobs including replacing the tired old rear shock & had the front forks overhauled by local specialist. In fairness mine is now showing 53,000 on clock & has a slight rattle from the clutch that disappears when the lever pulled in.
By chance I purchased a set of  taper roller headset bearings & seals from "Marksman" but in the event after checking/cleaning/regreasing/readjusting existing ones I didnt have to replace after all.  So if you are interested you can have these for £20 posted. Brand is "Codex"-they are good quality as are all products supplied by "Marksman"
I can vouch for their rear suspension linkage bearings which were a fraction of the cost of Yamaha OEM & every bit as good!
PM me if interested. Dave

Cheers buddy! It's been good so far, much less intense ride this morning compared to the ZX6R, yet still not hanging about.
There is no chance that this headstock bearing can be spun around, there is a big notch at 12oclock, the bars rest / slot into this gap. I'm sure i could move it but for the sake of a few pennies, a days work and a chance to chillin with the bike it shall be replaced!

It's not too bad of nick. No cracks and no major scratches, i'm sure it will polish up well.
It's been stood outside so the front brace around the fairing and clocks looks a little bit worn



I will do a service on it out of principal, Sparks, plugs, air filter and oil filter. Valves are hopefully ok i don't want to get too involved. Runs spot on other than a little tick
Carb rubbers need replacing
Headstock
Manual Cam Chain Tensioner, currently ticks on tickover, disappearers on anything over and sounds like a sewing machine (recommendations anyone?)
Renthal 758's Ultra Low (or 789s) handle bars
Belly Pan
Mudguard
Scottoiler to remove


I would also like to fit a set of matching Michelins, although currently mixed tires and old it feels very well planted.



These bearings you speak of, i assume that's the full kit, seals, upper and lower bearings with races?
Let me know, chances are i will have them off you.

Let me know if we can sourceother parts as well


Thats the full kit ie taper roller bearings,races & seals. I phoned Marksman at the time I ordered & they assured me they were a good brand.
Re your carb rubbers_I replaced mine in July got them from M&P Swansea-£69-99. Also bought carb overhaul kits from them. Transformed the fuelling after carb balance. Tyres; I am running Michelin PR3s Good tyres!
[/quote]