Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Vibration issue
#4
Came from 09 xj6 to a foxeye (4th fzs6 iv owned). I was genuinely surprised at the level of vibes between the two. Pillion rider immediately spotted it thru the footrests. The xj was sewing machine smooth throughout the rev range. I just figure good fuel injection was the difference versus carbs. The current foxeye tach needle stays rock solid on idle so I just crack on and rideĀ  Smile .. ps arent carburettors usually balanced at a higher rpm rather than on idle??
Better to have it and not need it than to need it and not have it...
Reply


Messages In This Thread
Vibration issue - by phil mcglassup - 16-09-16, 07:31 AM
Re: Vibration issue - by BBROWN1664 - 16-09-16, 09:03 AM
Re: Vibration issue - by phil mcglassup - 16-09-16, 10:10 AM
Re: Vibration issue - by misterjayb1 - 16-09-16, 07:37 PM
Re: Vibration issue - by phil mcglassup - 16-09-16, 08:38 PM
Re: Vibration issue - by misterjayb1 - 16-09-16, 09:13 PM
Re: Vibration issue - by phil mcglassup - 17-09-16, 08:30 AM
Re: Vibration issue - by darrsi - 17-09-16, 08:43 AM
Re: Vibration issue - by phil mcglassup - 17-09-16, 04:47 PM
Re: Vibration issue - by darrsi - 17-09-16, 04:51 PM
Re: Vibration issue - by Jules-C - 17-09-16, 09:42 PM
Re: Vibration issue - by Html33 - 21-09-16, 08:15 AM
Re: Vibration issue - by phil mcglassup - 21-09-16, 12:57 PM
Re: Vibration issue - by Kentish - 02-10-16, 10:21 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)