Clutch draggin when hot

[tex1507]

The springs in particular as the heavy springs can cause problems with the sprocket cover mechanism

Ensure the sprocket cover adjustment is done correctly

Screw in the cable adjuster full at the lever end.
Remove the rubber bung on the sprocket cover
Loosen the lock nut with a deep spanner ( it will loosen with a crack and frighten the crap out of you)
Turn the lock nut anti clockwise a full turn
Hold you fingers lightly on the clutch lever
Turn the centre screw clockwise with a good fitting flat screwdriver
You will feel the lever moving out
Keep turning the screw until the lever is about 5 to 6mm from the lever housing.
Tighten the locknut.
Replace the rubber bung
Take the final adjustments at the cable adjuster
Read this post also http://foc-u.co.uk/index.php/topic,10124...#msg105622

You may have to resort as I did and replace the friction plates with OEM also, they are expensive but never had any issues afterwards

All Sorted, as a temp solution I have put my old springs back in while waiting for new springs from Yamaha.
all issues with the clutch dragging have now disappeared and this is still with the EBC friction plates so am now finally
happy with bike again and not about to launch it onto the scrap pile. 

Cheers all for your Help and advice.

Stu