31-08-16, 08:39 PM
So I just took the whole cable out from the wiring box under the tank, there are no cuts in the wire; to be sure I triple span round it with insulation tape, connection on both ends are clean, I don't have a multimeter to check how the connection really is though.
I replaced the front wheel a couple of days ago, my replacement ceramic piece is in there fine, the two lugs have not broken off.
Does anyone have any more ideas? :'(
There were 3 wires, but they did not go into the back of the clocks.
I replaced the front wheel a couple of days ago, my replacement ceramic piece is in there fine, the two lugs have not broken off.
Does anyone have any more ideas? :'(
(12-07-16, 08:36 AM)Fazer99 link Wrote: Check all the wiring that leads from the back of the clocks to the sensor on the front wheel as thare might be a break in one of the 3 wires, this does mean you will have to cut open the "protective tubing" to view clearly all of the wires. Once checked and repair fixed (if there is damage) re cover the wires with at least 3 layers of insolation tape as to be honest that will be more protective than that tubing they use any way.
had to do this to my bike.
There were 3 wires, but they did not go into the back of the clocks.