18-06-16, 03:45 PM
Hello,
Did my measurements and:
coil 1-4, primary 2,5Ohm, secondary 15,76Ohm
coil 2-3, primary 2,6Ohm, secondary 15,69Ohm
Now to the caps:
1 - 9,6kOhm
2 - 9,6kOhm
3 - 10,75kOhm
4 - 89kOhm
So coil seems fine, but caps are weird (specs says 10kOhm). It still wont start, but if I give it some throttle it will but it will work unevenly (like 3 cylinder) and after some time there will be gasoline driping from near carburetors (is it normal?)
What are you recommendations - replace caps? If yes - what are NGK model numbers?
Did my measurements and:
coil 1-4, primary 2,5Ohm, secondary 15,76Ohm
coil 2-3, primary 2,6Ohm, secondary 15,69Ohm
Now to the caps:
1 - 9,6kOhm
2 - 9,6kOhm
3 - 10,75kOhm
4 - 89kOhm
So coil seems fine, but caps are weird (specs says 10kOhm). It still wont start, but if I give it some throttle it will but it will work unevenly (like 3 cylinder) and after some time there will be gasoline driping from near carburetors (is it normal?)
What are you recommendations - replace caps? If yes - what are NGK model numbers?