Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Picasso....
#17
(16-06-16, 03:46 PM)anutz link Wrote: any thoughts or experience with lacquer....not sure if i should, have read about people ruining the job after getting this far....no idea really...

As a Panel beater paint sprayer I should say yes I have experiance with lacquer but it has been over 15 years since doing anything like that. I painted my old FZR and didn't use any lacquer and had no problems, as long as you use a strong paint then you should be fine as yes if you mess the lacquer up it's a possible start over.


Attached Files Thumbnail(s)
   
RIP my beautiful red beast 1999 to 2017 ???
Reply


Messages In This Thread
Picasso.... - by anutz - 14-06-16, 06:35 PM
Re: Picasso.... - by joebloggs - 14-06-16, 07:05 PM
Re: Picasso.... - by anutz - 14-06-16, 07:16 PM
Re: Picasso.... - by chris.biker - 14-06-16, 07:19 PM
Re: Picasso.... - by anutz - 14-06-16, 07:29 PM
Re: Picasso.... - by fazersharp - 14-06-16, 08:34 PM
Re: Picasso.... - by anutz - 14-06-16, 09:17 PM
Re: Picasso.... - by anutz - 15-06-16, 08:03 PM
Re: Picasso.... - by anutz - 16-06-16, 02:33 PM
Re: Picasso.... - by fazersharp - 16-06-16, 02:40 PM
Re: Picasso.... - by anutz - 16-06-16, 02:41 PM
Re: Picasso.... - by anutz - 16-06-16, 02:50 PM
Re: Picasso.... - by joebloggs - 16-06-16, 03:30 PM
Re: Picasso.... - by anutz - 16-06-16, 03:36 PM
Re: Picasso.... - by anutz - 16-06-16, 03:45 PM
Re: Picasso.... - by anutz - 16-06-16, 03:46 PM
Re: Picasso.... - by Fazer99 - 16-06-16, 03:56 PM
Re: Picasso.... - by fatbloke62 - 16-06-16, 04:03 PM
Re: Picasso.... - by anutz - 16-06-16, 04:45 PM
Re: Picasso.... - by Fazer99 - 16-06-16, 05:44 PM
Re: Picasso.... - by anutz - 16-06-16, 05:50 PM
Re: Picasso.... - by fazersharp - 16-06-16, 06:00 PM
Re: Picasso.... - by anutz - 16-06-16, 06:40 PM
Re: Picasso.... - by joebloggs - 16-06-16, 06:44 PM
Re: Picasso.... - by anutz - 16-06-16, 07:06 PM
Re: Picasso.... - by sinto607276 - 16-06-16, 09:33 PM
Re: Picasso.... - by anutz - 16-06-16, 10:06 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)