How to fit retrolab projectors?

[sinto607276]

Left the angel eyes out as I didn't fancy hacking any wires in half.

Lights come on like standard do dipped on one side and both when on full beam.

I may do the dual headlight mod.

I should note I haven't used the loom supplied with the kit as I wasn't confident in hacking the bike loom connector in half.

All seems well at the moment if any problems arise I will use the loom that came with the projectors.

Think you may of picked me up wrong or my description wasn't too good, I'll try and explain......

The spade connectors you have at the end of your NEW light loom should just slot into the existing bike wires at the original place that it connects to original bulbs, you may however have to open the NEW block and remove the spades and then just plug them in.

I'd be interseted in this set up if I could be convinced that I could get 2 low beam and also 2 high beam when I flick the button.
Do the both of your lamps have or can take H4 bulbs?