01-03-16, 09:49 AM
Grab yourself a piece of 10mm alluminium checker plate from a metal supplier/fabricator about 750mm wide by 600mm long and drill about an 8mm hole in either end of the 750mm wide side about 30mm from the edge and countersink the holes, get a couple of 8mm stainless steel countersunk screws about out 50mm long, put them through the the checker plate wind a couple of nuts and washers on the back. Rest the bolts on the bottom timber plate/door threshold where you want to position the ramp and clout the two screws with a hammer just hard enough to mark the threshold, drill two 10mm holes in threshold on the marks, now the ramp will locate in the holes so not move when you push or ride the bike into the shed and when not in use the flat piece of checker plate will stand against the wall just inside the shed. Jobs a Gudun.