26-02-16, 12:44 AM
The visible screws in the picture are not for removing the switch, they are part of a set of 4 for keeping the sealing plate and wire guide in place.
2 pan head screws hold the switch to the frame and can only be accessed from underneath and are loctited in place.
Ensure you have a good fitting philips screwdriver but there is a good chance they will be wrecked on the way out.
Use an impact screwdriver to remove as it will fit cleanly and replace then with normal bolts or allen bolts and loctite them back in place.
If switch falls off when riding the engine will stop dead.
2 pan head screws hold the switch to the frame and can only be accessed from underneath and are loctited in place.
Ensure you have a good fitting philips screwdriver but there is a good chance they will be wrecked on the way out.
Use an impact screwdriver to remove as it will fit cleanly and replace then with normal bolts or allen bolts and loctite them back in place.
If switch falls off when riding the engine will stop dead.