My FZS600, modding in Oz.

[Nebuchernezzer]

Measured up the clamps on my danmoto adjustable clip ons this morning.  The clamps that go around the fork legs are 24mm thick/high (whatever you want to call it).
I have 20mm of fork tube above the triples plus 2mm of thickness for the top cap.
Basically i feel i have enough room to try out the clipons above the top triple, which on a fazer is probably the best place for them if you want to keep the fairing (which i do).
It'll be a good intermediate riding position (i'm hoping!), while not being too nose down (i'm hoping!) .
Not sure if i'll push the forks through another few mm to get 24mm above the triples, i'll probably go down the route of just milling a few mm off the danmoto clip on clamp instead though.
Mounting perhaps will end up like this bike.