29-11-15, 02:39 PM
Cut the guard down further, difficult to loose a line where the lower part of the guard meets the tray for CDI, think it would take a lot of work to lose it completely so may just have to stay as it is
![[Image: WP_20151129_002.jpg]](http://s19.postimg.org/vqipv367n/WP_20151129_002.jpg)
The small tube protruding from the bottom contains a fastener, unless I run you over your not really going to notice it :eek
![[Image: WP_20151129_003.jpg]](http://s19.postimg.org/4engtr1gz/WP_20151129_003.jpg)
![[Image: WP_20151129_005.jpg]](http://s19.postimg.org/w0q8efktv/WP_20151129_005.jpg)
I think it looks better than my 1st attempt
Just need to knock up a bracket for the numberplate
The small tube protruding from the bottom contains a fastener, unless I run you over your not really going to notice it :eek
I think it looks better than my 1st attempt
Just need to knock up a bracket for the numberplate
Complete fabrication, I didn't make it up!