Better off checking them first as there is no hard and rule to the shim sizes.
Check the clearances of all 16 valves, if any are out of spec then remove the cams buckets and shims. Lay them on a clean smooth surface with the clearances and the shim sizes written down. Don't mix up the buckets and shims. With a little bit of ingenuity you may be able swap them around enough that you do not need to buy any or just one or two.
OEM are about £8, WeMoto do them for half that.
Check with you loacal dealer first as he might be willing to swap or sell some.
You will need to have a micrometer to check the sizes as some of the etching may be worn off.
The etched number is not always 100% accurate either :eek
Check the clearances of all 16 valves, if any are out of spec then remove the cams buckets and shims. Lay them on a clean smooth surface with the clearances and the shim sizes written down. Don't mix up the buckets and shims. With a little bit of ingenuity you may be able swap them around enough that you do not need to buy any or just one or two.
OEM are about £8, WeMoto do them for half that.
Check with you loacal dealer first as he might be willing to swap or sell some.
You will need to have a micrometer to check the sizes as some of the etching may be worn off.
The etched number is not always 100% accurate either :eek