Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Stuttering at 7000 rpm
#17
Right. I went over the bike with a fine tooth comb and couldn't find anything, so i remembered that the last couple of days when taking the bike out there was a slight scraping sound (like stones caught in the rear tyre tread. Upon further investigation the shape of the hugger (puig) about 3" from the end is very close to the tyre. I touched the hugger and rotated the wheel and hey presto there was the exact sound! I looked under the hugger and it's worn at one point. I then checked the tyre at the same area of the wear mark and there is a very small flat spot just off centre. I will change the rear wheel tomorrow and see if that is the problem :rolleyes
If it's broken, it's not fixed.
Reply


Messages In This Thread
Stuttering at 7000 rpm - by nickodemon - 25-10-15, 04:30 PM
Re: Stuttering at 7000 rpm - by Falcon 269 - 25-10-15, 07:01 PM
Re: Stuttering at 7000 rpm - by nickodemon - 25-10-15, 07:50 PM
Re: Stuttering at 7000 rpm - by nickodemon - 25-10-15, 08:01 PM
Re: Stuttering at 7000 rpm - by Falcon 269 - 25-10-15, 10:24 PM
Re: Stuttering at 7000 rpm - by nickodemon - 25-10-15, 10:58 PM
Re: Stuttering at 7000 rpm - by Falcon 269 - 26-10-15, 06:59 AM
Re: Stuttering at 7000 rpm - by nickodemon - 26-10-15, 06:14 PM
Re: Stuttering at 7000 rpm - by NorthWestern - 26-10-15, 07:37 PM
Re: Stuttering at 7000 rpm - by nickodemon - 26-10-15, 08:02 PM
Re: Stuttering at 7000 rpm - by NorthWestern - 26-10-15, 08:29 PM
Re: Stuttering at 7000 rpm - by nickodemon - 26-10-15, 08:35 PM
Re: Stuttering at 7000 rpm - by NorthWestern - 26-10-15, 08:45 PM
Re: Stuttering at 7000 rpm - by nickodemon - 26-10-15, 09:03 PM
Re: Stuttering at 7000 rpm - by NorthWestern - 26-10-15, 09:13 PM
Re: Stuttering at 7000 rpm - by nickodemon - 26-10-15, 11:24 PM
Re: Stuttering at 7000 rpm - by nickodemon - 27-10-15, 11:53 PM
Re: Stuttering at 7000 rpm - by nickodemon - 30-10-15, 06:35 PM
Re: Stuttering at 7000 rpm - by nickodemon - 26-10-15, 09:45 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)