30-07-15, 10:50 AM
Are you sure it's 100 nms seems a lot, you do mean the bolts that hold the sprocket to the hub?
A 100nms coverts to 73.76 foot pounds, using a 1/2 drive standard ratchet wrench the most you can get without swinging on it is around 75 foot pounds, ok some will get more but the fitter who told me set up a bolt in a vice and I was within a couple of pounds of it, so it's ok as a guide.
I took my rear sprocket off to paint a few months ago and didn't tighten them up that tight but I did use thread lock.
A 100nms coverts to 73.76 foot pounds, using a 1/2 drive standard ratchet wrench the most you can get without swinging on it is around 75 foot pounds, ok some will get more but the fitter who told me set up a bolt in a vice and I was within a couple of pounds of it, so it's ok as a guide.
I took my rear sprocket off to paint a few months ago and didn't tighten them up that tight but I did use thread lock.